![]() R2 is a standby router with Ip address 10.10.10.2 / 24.R1 is acting an Active router with IP address 10.10.10.1 /24.Let’s issue HSRP troubleshoot command here Same configuration as R1 for Routing protocol and also for interface ethernet 0/0 and 0/1 are configured with. Here is the basic EIGRP configuration for our lab, we have allowed an IP address on the network by issuing network 0.0.0.0. We will shut down R1 and after 10 seconds of HSRP hold time R2 will take over active router role, and the ICMP traffic will go through R2. P1 will ping to PC2 1st R1 will act as an active router and R2 will be standby router. This Lab will show you how to configure basic HSRP on GNS3 IOU image and Capture the packets via Wireshark*. V2 (mac address multicast address 224.0.0.102)ĭefault hello interval 3sec & hold time 10sec.V1 (mac address multicast address 224.0.0.2 ). ![]() It is a Cisco proprietary protocol and using an Active router and Standby Router. HSRP stands Hot Standby Router Protocol, gives us default redundancy, load balance, and fault tolerance.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |